23rd July 2016
Last night was an early one, so it's hardly surprising that this morning was also an early start! I was up at 6am, and ready to get going by 8:00, however I was just about to cast off when I remembered that I had left the motorbike in the van! Fortunately I was only parked 2 minutes walk from the mooring, and by wheeling the bike down to the mooring I didn't have to start the engine and disturb the peace and quiet so early on a Saturday morning.
I was sorry to leave this lovely quiet mooring. Once under way, there were three locks to negotiate, one being the very deep Castle Mill lock. The procedure when on your own is as follows, assuming the lock is ready for you with the bottom gate already open. If not you have to get the lock ready by mooring up, emptying the lock, and then opening the bottom gate, a procedure which can delay passage by up to 10 minutes.
1) Drive into the lock, placing your helm position by a ladder. DON'T turn off the engine - you may need to jump back on and manoeuvre the boat in a hurry!
2) Get your centre rope / ropes (in my case) and put them over your shoulders, uncoiled so they can trail down in front of you and down in between your arms - you don't want to lose them, or you will lose the boat!
3) Carefully climb off the boat and onto the ladder, then ascend slowly, making sure the ropes pay out behind you and you don't trip on them or slip on the slimy rungs.
4) Once on the side of the lock, tie the boat up and close the bottom gate, then start filling the lock, constantly making sure there is plenty of slack in the ropes and the boat won't get pulled over by being tied too tight.
5) When the lock is full, open the top gates, drive out, moor on the upstream landing stage, and go back and reset the lock if nobody is coming downstream. (All Nene and Great Ouse locks are supposed to be left empty and with the guillotine gate open)
This lot can take up to half an hour per lock, which is why canal and river distance is often measured in lock - miles. (Add the number of locks to the distance travelled). The three locks negotiated, I soon arrived at Priory Marina, a very well run marina owned by the Canal and Rivers Trust (formerly British Waterways), and filled my nearly empty water tank before wandering over to the office to ask where they wanted me to put the boat. The great thing about boating today is that you can contact the marinas a couple of days ahead of arrival, having a much better idea of when you will get to your destination, and book only the days you need.
Once on the mooring, I had lunch, and then a lazy cycle ride back to Great Barford along the very beautiful "National Cycle Route 51," to collect the van. Final jobs on board included stripping the beds, packing everything up and taking it all home for washing. Goodbye, "Escape,"moped, motorbike, see you in a week.
Last night was an early one, so it's hardly surprising that this morning was also an early start! I was up at 6am, and ready to get going by 8:00, however I was just about to cast off when I remembered that I had left the motorbike in the van! Fortunately I was only parked 2 minutes walk from the mooring, and by wheeling the bike down to the mooring I didn't have to start the engine and disturb the peace and quiet so early on a Saturday morning.
I was sorry to leave this lovely quiet mooring. Once under way, there were three locks to negotiate, one being the very deep Castle Mill lock. The procedure when on your own is as follows, assuming the lock is ready for you with the bottom gate already open. If not you have to get the lock ready by mooring up, emptying the lock, and then opening the bottom gate, a procedure which can delay passage by up to 10 minutes.
1) Drive into the lock, placing your helm position by a ladder. DON'T turn off the engine - you may need to jump back on and manoeuvre the boat in a hurry!
2) Get your centre rope / ropes (in my case) and put them over your shoulders, uncoiled so they can trail down in front of you and down in between your arms - you don't want to lose them, or you will lose the boat!
3) Carefully climb off the boat and onto the ladder, then ascend slowly, making sure the ropes pay out behind you and you don't trip on them or slip on the slimy rungs.
4) Once on the side of the lock, tie the boat up and close the bottom gate, then start filling the lock, constantly making sure there is plenty of slack in the ropes and the boat won't get pulled over by being tied too tight.
5) When the lock is full, open the top gates, drive out, moor on the upstream landing stage, and go back and reset the lock if nobody is coming downstream. (All Nene and Great Ouse locks are supposed to be left empty and with the guillotine gate open)
This lot can take up to half an hour per lock, which is why canal and river distance is often measured in lock - miles. (Add the number of locks to the distance travelled). The three locks negotiated, I soon arrived at Priory Marina, a very well run marina owned by the Canal and Rivers Trust (formerly British Waterways), and filled my nearly empty water tank before wandering over to the office to ask where they wanted me to put the boat. The great thing about boating today is that you can contact the marinas a couple of days ahead of arrival, having a much better idea of when you will get to your destination, and book only the days you need.
Once on the mooring, I had lunch, and then a lazy cycle ride back to Great Barford along the very beautiful "National Cycle Route 51," to collect the van. Final jobs on board included stripping the beds, packing everything up and taking it all home for washing. Goodbye, "Escape,"moped, motorbike, see you in a week.
No comments:
Post a Comment